KAWASAKI MULE PRO FXT SIDE ENCLOSURE KIT
Side Enclosure for MULE PRO FXT. Use our side enclosures with our rear windjammer to create an enclosure when used with your roof and windshield. Side enclosures work with hard front, our soft rear windshields., soft tops and hard tops. Doors are completely removable and have full length double pull zippers. Side enclosures comes complete with necessary hardware , installation and care instructions and are priced as a pair ( 2 driver, 2 passenger). Doors can be zipped out and removed for added ventilation on warmer days. MADE IN USA! Save $20.00 when you add a rear windjammer to a side enclosure order!
PRODUCT INFO
Made from solution dyed Sunmaster Polyester material with durable waterproof coating on backside of material. Exceptional UV resistance and heavyweight material make this side enclosure perfect to leave on all year if needed.
WARRANTY / RETURN & REFUND POLICY
15 Day Return Policy on non defective products. 1 year warranty on materials and workmanship.
SHIPPING INFO
Real time shipping calculations from UPS and USPS based on weight, size and location shipped to.
WHAT DOES IT FIT?
KAWASAKI MULE PRO FXT ALL. DOES NOT FIT PRO FX.
INSTALLATION INSTRUCTIONS
KAWASAKI MULE PRO FXT SIDE ENCLOSURES
Installation Instructions
- From side of MULE PRO®, install front sections of side covers against roll cage/frame so straps will engage roll bar along the top, rear and sides. Covers will attach to outside edge of roll cage and should be level and straight with cage frame leaving straps slightly loose until doors are zipped in. Front elastic strap clips to plastic lip under front fender. Repeat for other side.
- Attach elastic loop on side enclosure door around door on Mule as shown below. Zip front doors in place. (1 left, 1 right)
- Adjust side enclosures around roll bar by tightening straps from top first then down each side of side enclosure.
- Install rear sections similar to front sections by attaching straps around top and back or roll cage leaving them loose.
- Attach elastic loop on rear side enclosure door around door on Mule as shown below. Zip rear doors in place. (2 left, 2 right)
- Tighten all straps around rear section of side enclosure to be level and match contour of roll cage. Attach rear section to front section Velcro near center roll bar upright.
- Before supplied Velcroâ can be installed, you must clean areas with alcohol. It is not necessary to use Velcro on doors and can make it easier to get in and out of Mule without Velcro installed. If you require a air tight solution then you can proceed to installing along top edge of doors to match Velcro mate on cover.
- Install supplied Velcro around sides and door openings corresponding to Velcro mate on cover if desired.
- Attach bottom of side enclosure zippered door to plastic on top of doors. Doors will be able to be opened while attached to doors if zipper is unzipped to where window turns down along windshield.
Your new cover is guaranteed against any defects in material and workmanship for 1 year from the date of purchase. Should any problems arise, please contact your dealer. No warranty card is necessary.
Your UTV has several warning and caution labels around the machine that may be covered when this cover is installed. It is your responsibility as the UTV owner to read and understand these warnings as well as making sure anyone who operates the UTV is aware of the proper operation.